Our Solutions
 
  Inverter Batteries
Inverter Load Analysis
 
 
Step Down Transformers
 
  Computers
  Refrigerators
  General Supplies
  Photo Gallery
 
   
   
  You are here >> Home >> Step Down Transformers  
Step Down Transformers  
 

Step down transformers are designed to reduce electrical voltage. Their primary voltage is greater than their secondary voltage. This kind of transformer "steps down" the voltage applied to it. For instance, a step down transformer is needed to use a 110v product in a country with a 220v supply.

Step down transformers convert electrical voltage from one level or phase configuration usually down to a lower level. They can include features for electrical isolation, power distribution, and control and instrumentation applications. Step down transformers typically rely on the principle of magnetic induction between coils to convert voltage and/or current levels.

Step down transformers are made from two or more coils of insulated wire wound around a core made of iron. When voltage is applied to one coil (frequently called the primary or input) it magnetizes the iron core, which induces a voltage in the other coil, (frequently called the secondary or output). The turns ratio of the two sets of windings determines the amount of voltage transformation.

An example of this would be: 100 turns on the primary and 50 turns on the secondary, a ratio of 2 to 1.

Step down transformers can be considered nothing more than a voltage ratio device.

With step down transformers the voltage ratio between primary and secondary will mirror the "turns ratio" (except for single phase smaller than 1 kva which have compensated secondaries). A practical application of this 2 to 1 turns ratio would be a 480 to 240 voltage step down. Note that if the input were 440 volts then the output would be 220 volts. The ratio between input and output voltage will stay constant. Transformers should not be operated at voltages higher than the nameplate rating, but may be operated at lower voltages than rated. Because of this it is possible to do some non-standard applications using standard transformers.

Single phase step down transformers 1 kva and larger may also be reverse connected to step-down or step-up voltages. (Note: single phase step up or step down transformers sized less than 1 KVA should not be reverse connected because the secondary windings have additional turns to overcome a voltage drop when the load is applied. If reverse connected, the output voltage will be less than desired.)

Voltage Transformer Chart
The table below will let you easily see all the models and sizes we carry.


"Type A"
Step Down
Transformers
220/240 to 110/120

"Type A"
Step Up/Down Transformers
220/240 <-> 110/120


"Type B"
Step Up/Down Transformers
220/240 <-> 110/120


"Type D"
Step Up/Down Regulator/Transformers
220/240 <-> 110/120
 
       
         
         
         
Home  I     Company  I     Inverters  I     Solar Energy  I     Our Clientele  I     Contact  
Copyright © 2011 Solar King Industries Ltd. All Rights Reserved.